MTC Series, Process
Controllers
Process • Controller
STANDARD FEATURES
Standard with Lufran® baths & inline heaters
- Microprocessor based
controller.
- A type-J
thermocouple.
- Three mode (PID)
with autotuning.
- System power module.
- 24 VAC controller
supply.
- Membrane panels,
digital display.
STANDARD DISPLAY
FACEPLATE
|
STATUS |
ALARM |
INPUT |
|
|
- High Alarm
- Liquid Level
- Overtemp
- Purge
- System
|
- Power
- Save/Silence
- Setup
- Up/Down
- Return/Reset
- Timer Start
- Timer Stop/Reset
- Heater On/Off
|
NOTE:
Additional displays available on FEC-J, SBC-J, LTFEC-J, NEC-J and TIHC-J models.
STANDARD FEATURES
- Multiple setup
functions.
- Integral timer with
pre-warn alarm count up/down function.
- Redundant high
limit-overtemp.
- Full one year
warranty.
- "Lock out" access
code.
- Drain / temperature
(safety) interlock.
- Chemical resistant
panel.
- Alarm silence key.
OPTIONS
- RS232 or SECSII
communication.
- Remote mountable
alarm (buzzer).
SPECIFICATIONS
Temperature
Controller
- Ambiant Operating
Temp Range: 0 to 50°C.
- Indicating Temp
Range: 0 to 199.9°C.
- Storage Temp:
-40 to 60°C.
- Weight:
Approximately 4 - 1/4 lbs. (1.9 kg).
- Temp Resolution:
0.1 degree C.
- Noise Rejection:
At 60 HZ; NMR - 60 db, CMR 120 db.
- Connection:
Rear AMP CPC connector screw type, 10, 32 30 amp/600v.
- Sensor:
Standard type J-thermocouple, cold junction compensation, up scale break
protection.
- Power: Use
Lufran® model 978PB power module only.
- Set Up Memory:
EEPROM, all parameters.
- Display:
Seven segment LEW uniplanar numerals. Desecrate LEDs (red, green, amber).
Power Module
- Temp Range: 0
to 100°C.
- Ambiant Operating
Temp Range: 0 to 50°C.
- Weight:
Approximately 4 lbs. (1.8 kg).
- Power:
208/240, 3 wire neutral, 20va.
- Output:
Depending on configuration - Heater: SSR, 25 amps, pump relay: 120 vac, 1/2
HP.
For more information, prices and availability please visit our contact
page.
